How To Make A Photo Box For Jewelry

Use A Favorite Photo To Make This Easy Epoxy Jewelry Box From A Beautiful Mess!

Use a pencil to draw one line near the box's edges and connect the points. If you make them about 1″ wide, then you can know how many you need to make to fill your box (a 5″ wide box would need 5 rolls, etc.). Cut out your cardboard light box.

Use The Paper To Cover Over The Holes You Have Created, And Tape The Paper To The Box.

This double decker quilled jewelry box from vikalpah has us all wound up! After setting up your photography lightbox: Make sure at this point, that you have the smooth side of the panels facing up (these will be the inside of your box) also take a few moments to look at the inside edges of your squares, where all the points touch the center square and make sure you line them up perfectly.

Make Sure The Lighting Is Perfect.

See more ideas about photographing jewelry, jewelry photography, jewelry. The square base of the box is 6 cm x 6 cm, and as you can see they’re very simple to make and really cheap. Mark a point approximately 5.1 cm (2 inches) with a ruler from every edge on the side of the diy light box.

My Fiance Sara Is Turning 30, And Since The Week We Met, She’s Been Asking Me About A Jewelry Box.

Now tape the larger piece of paper to the back of the box, and allow it to curve down to the floor of the
box. How do you use a light box when taking photos of jewelry? Locate the box on one of the sides for the flaps to be open in front of you.

The Best Way To Photograph Jewelry Is With A Mirrorless, Dslr Camera.

Set up your camera on a stable platform. Trim the white tissue paper to the same dimensions and tape it to the box. Cut and roll all your pieces and pin in place for now.